Managing Failed and Partial Executions On-Chain

On-chain trades can revert (fail and still cost gas), partially fill, or sit pending while the market moves. Common causes include slippage limits being breached, insufficient gas, expired deadlines, nonce conflicts and network congestion. Managing them requires pre-set rules for retrying, replacing or cancelling, plus reconciliation afterward.

Key takeaways

  • A reverted transaction still pays network fees in most cases.
  • Partial fills create unintended positions that must be completed or unwound.
  • Stuck transactions block later ones from the same address because of nonce ordering.
  • Track failure rate, wasted gas and time-to-fill to improve execution settings.

Sending a transaction is not the same as completing a trade. On-chain execution produces a range of outcomes, and each needs a different response. This guide covers causes, costs, a worked example, decision rules and controls. For wider execution context, see on-chain vs. off-chain trading and settlement finality.

Outcomes and Their Causes

Outcome Typical causes Cost
Reverted Price moved beyond slippage limit; deadline expired; insufficient allowance or balance Gas spent; no trade
Partial fill Limit order on an order book or intent system filled in pieces; liquidity ran out Unbalanced exposure
Pending / stuck Gas price too low during congestion; nonce gap Opportunity cost; blocks later transactions
Dropped Removed from mempool after long wait Must resubmit; price may have moved
Executed at worse price Loose slippage setting; MEV sandwich Hidden cost
Bitcoin and Ethereum coins in front of a market chart illustrating how on-chain executions can fail or partially fill under network stress
On-chain execution can fail, partially fill, or timeout under network stress

Worked Example: A Rebalance Under Congestion

Illustrative only. A treasury needs to swap $500,000 USDC into ETH during a volatile hour, using three $166,667 transactions with a 0.3% slippage limit.

Transaction Outcome Cost
1 Filled Pool fee + gas ($12)
2 Reverted: price moved 0.5% before inclusion Gas wasted ($18)
3 Stuck pending for 20 minutes; replaced with higher gas Gas ($25); ETH up 0.8% meanwhile
Retry of 2 Filled after slippage limit raised to 0.6% Extra ~0.4% price cost ($670)

Total extra cost from failures and delays: roughly $1,000–1,800, plus the operational time. Pre-set rules would have defined in advance whether to widen slippage, wait or switch venue.

Decision Rules: Retry, Replace or Cancel

Situation Rule of thumb
Reverted on slippage Re-quote; retry only if the new price is within your maximum acceptable cost
Stuck due to low gas Replace with the same nonce and higher fee, or cancel with a zero-value self-transfer
Partial fill Decide in advance: complete within X minutes or unwind the filled part
Repeated failures on one venue Pause and route elsewhere
Network-wide congestion Delay non-urgent transactions
Two bitcoin coins over a trading chart representing how execution discipline protects portfolio alignment before settlement
Execution discipline protects portfolio alignment before settlement occurs

Pre-Trade Controls

  1. Simulate transactions before sending to catch reverts.
  2. Set slippage limits by asset and size, with a documented maximum.
  3. Use realistic gas settings and transaction deadlines.
  4. Manage nonces centrally for addresses used by multiple systems.
  5. Use protected routing to reduce MEV; see latency arbitrage controls.

Post-Trade Controls

  1. Reconcile intended vs. actual positions after each batch.
  2. Log failures with cause, gas cost and resolution.
  3. Review slippage and gas settings weekly.

Measurable Indicators

  • Failure / revert rate per venue and network.
  • Gas wasted on failed transactions.
  • Median time from submission to inclusion.
  • Partial-fill frequency and average completion time.
  • Realized slippage vs. quote.

Where Controls Still Fail

Extreme volatility can make any slippage limit either too tight (repeated reverts) or too loose (poor fills). Network outages and sequencer halts on layer 2s stop execution entirely. The best defence is sizing that does not require urgent execution.

Free educational tool

How much execution risk suits you?

The Crypto Risk Profile Quiz helps you think through your tolerance for technical and trading risk.

Take the Crypto Risk Profile Quiz →

Educational tool. Results are not investment advice.

Work With Kenson Investments

Kenson Investments’ digital asset specialists focus on education around execution and settlement. Explore our risk management services or contact the team to learn more.

Disclaimer: The information provided on this page is for educational and informational purposes only and should not be construed as financial advice. Digital assets involve significant risk, including the possible loss of principal, and past performance is not indicative of future results. Always conduct thorough research and consult a qualified financial advisor before making investment decisions.

Digital asset regulation in the United States is still developing. Some areas, such as payment stablecoins, now have a federal framework, but comprehensive market-structure legislation has not yet been enacted. None of the information provided by Kenson LLC should be considered financial investment advice. Please consult your Registered Financial Advisor for guidance. Kenson LLC does not offer any products regulated by the SEC, including equities, registered securities, ETFs, stocks, bonds, or equivalents.

References

Get In Touch

Want to dive deeper?

Our subscribers get exclusive access to extended strategy reports and consulting tools. Share your email to unlock more digital asset intelligence.